WatermelonElf Bar 600 Pods (x2)

Savour the sweet and juicy flavour of Watermelon with Elf Bar 600 pre-filled pods. Made for use with the Elf Bar 600 pod kit, but also compatible with Elfa Pro and Tappo pod kits, each pod contains 2ml of vape juice and can deliver up to 600 puffs.

These 20mg nicotine nic salts provide a smooth satisfying vape which helps to curb nicotine cravings much quicker. Offering a typical MTL (Mouth To Lung) vaping experience, Elf Bar 600 pods will produce a modest cloud of vapour which replicates the sensation of using traditional tobacco.

No Messy Coil Changes or Re-filling

The Elf Bar 600 pod kit is an all-in-one system where you only need to charge the battery and replace the pod when it runs dry.

You also don’t need to worry about messy re-fills. You just use the Elf Bar 600pre-filled pods and replace with another.

No Messy Coil Changes or Re-filling

The Elf Bar 600 pod kit is an all-in-one system where you only need to charge the battery and replace the pod when it runs dry.

You also don’t need to worry about messy re-fills. You just use the pre-filled pods and replace with another.

How to use the Elf Bar 600 pod kit:

Charge the Battery: Although you might have a bit of power straight out of the box, it’s always best to give it a full charge. Just plug in a USB-C charging cable (not supplied) and wait around half an hour until the light flashes solid green.

Pod Prep: Remove the rubber stopper from the top and bottom of the pod.

Insert the Pod: Slide the pod back in to the device.

Soak the Coil: It’s important to leave the pod kit upright for around 10 minutes to ensure the coil is properly primed. Otherwise you might run the risk of burning the coil.

Vape Away!: With this quick bit of prep, you’re ready to vape. Just put your lips to the mouthpiece and inhale. No buttons, no switches. And when your battery runs low, just pop it on charge again after a days use (depending on usage).